Why is my Dimplex heater not working?
Most common reasons why a storage heater stops working completely is due to a faulty storage heater thermostat or a blown element. Dimplex suggest if you are a competent user comfortable taking off the front panel you may check to see if the thermostat is the cause of the problem (see below) to see if it can be fixed.
How do you unlock a Dimplex heater?
To lock the controls press and hold both the Back button and Enter for three seconds. Child Lock will appear at the bottom of the screen. To unlock the control repeat the action by pressing both the Back button and Enter for three seconds. Your Dimplex GFPE Panel comes pre-programmed with four timer modes.
How do you use a Dimplex heater timer?
The heater must be connected to the electricity supply for the timer to operate. Set the timer by rotating the dial clockwise until the correct time of day is indicated opposite the datum mark (located at centre front of the timer – see Fig. 5). Set the timer switch to position.
Where is the reset button on a Dimplex storage heater?
The Dimplex XLS24N will have a thermal cut-out on the top right hand side. Could be either a white or a brown plastic button that you press to reset it. When pressed you should feel it click.
Why has my electric storage heater stopped working?
If your storage heater stops working, there are two most common possibilities – a faulty thermostat and a broken element, provided that it was not covered by clothing accidentally. By performing a thermostat manual reset, it is possible to repair your storage heater. Turn off the power supply and remove it.
How do I sync my Dimplex heater?
Go into setup on the controller, press the sync icon, press the zone you want to sync to. On your heater, hold the V button for 3 seconds the. Press the down button, then the up button then the V button. The heater is now in sync mode.
How do you set a timer on a convector heater?
Turn the timer dial until the current time lines up with the arrow (2). 3. Pull out the segments (3) to set the time period/s during which you want the heater to be switched on for. It is possible at any time to slide the timer mode switch to position I to keep the heater on all the time or to 0 to switch it off.
Why is my electric storage heater not working?
Why is my storage heater clicking?
Answer: Your space heater makes a clicking noise because the surface materials are expanding and creating tension when they heat up. At some point, the tension releases and creates a clicking noise. After that, tension starts building up again, and after a few minutes, there will be another click.
