Why does my hot tub keep saying E02?
Is there an E02 error code displaying on your Lay-Z-Spa pump? This means your Lay-Z-Spa pump is experiencing a water flow issue. To clean the filter cartridge use luke warm water, run the filter cartridge under the water until the water runs clear. Do not use any detergent, washing up liquid or other chemicals.
Why is my lazy spa deflating?
According to the manufacturer, a Lay-Z Spa hot tub might deflate for one of two reasons – either the air valve is loose, or the spa is torn or punctured. Inflate the tub and spray the soapy water on the valve to check if it’s still leaking. If the hot tub is punctured, repair it with the provided repair patch.
Why is my Cleverspa deflating?
Deflation can be caused either by a seam failure, due to over inflation/direct sunlight or a puncture. In the first instance, please check all the valves are fitted correctly, with the screw thread on straight and tight.
Is it safe to go in a hot tub in the rain?
Yes, you can. It is good in both rain and snow because your body is warm even though your head may feel cold.
What is error code E02 on lazy spa?
E02 ERROR CODE REASON WATER LEVEL IS NOT CORRECT. The water flow sensors will not detect the water properly if the water is below the minimum line. on the spa liner.
What does E02 error mean?
The E02 error code can occur when the filters are dirty or blocked. SOLUTIONS WASH OR CHANGE THE FILTERS. Remove the filter cartridge from the filter housing. Using luke warm water, run the filter cartridge under the water until it runs clear.
Can I leave my CleverSpa on all the time?
Can you leave CleverSpa ® unattended whilst it heats? Yes, you can leave it unattended – the heater will switch off automatically when it reaches the set temperature. If leaving it on then you must ensure that it is connected into a specifically designed outdoor electrical socket so it is shielded from water.
Why is my CleverSpa making a noise?
Your CleverSpa® hot tub should not make a very loud noise when working correctly. Check your filter. If it is obviously dirty, either clean or replace. ENSURE THE FILTER IS NOT SCREWED ON TOO TIGHTLY AS THIS CAN CAUSE A LOUD NOISE AND/OR CAUSE THE TEMPERATURE GAUGE TO FLUCTUATE.
