What to do with a 400 day Schatz clock?
Do not force the spring, wind only until you find that the key will not readily turn further. when fully wound, your Schatz clock requires no further winding for 400 days. 8) Carefully place the glass dome into position, covering the clock. 9) To prevent loss, keep instruction booklet and key under the base of clock.
How to wind a 400 day Kundo clock?
Kundo 400 Day Clock Instruction Sheet ca. 1955 For the type of clock with pendulum locking device at the bottom rear of the movement. To wind this clock, put the key on the square and turn counterclockwise, 1/2 turn at a time. Release the key gently after each half-turn, don’t let let it snap back suddenly.
Can a 400 day clock be put in Beat Again?
17) Clock must be put “in beat” again, as explained in “Time Regulations”, paragraph 12. This Original Schatz 400 Day Clock with its graceful lines and silently rotating ball pendulum is a distinctive precision instrument that runs 400 days without rewinding.
What are the parts of a 400 day clock?
You will find the following clock parts: 1. Clock 2. Glass cover 3. Pendulum 4. Envelope containing a) Instruction booklet, b) Key, c) Spare suspension wire The cover of this clock is made of unbreakable glass. To clean off dust, etc. only use a very soft cloth or feather duster, thus avoiding scratches.
How many days does a Schatz 400 day clock run?
This Original Schatz 400 Day Clock with its graceful lines and silently rotating ball pendulum is a distinctive precision instrument that runs 400 days without rewinding. It has been accurately timed and approved before leaving the home of highly skilled Schatz craftsmen. Schatz Miniature 400 Day Clock Instruction Sheet ca. 1955
What kind of clock runs 400 days without rewinding?
This Original Schatz 400 Day Clock with its graceful lines and silently rotating ball pendulum is a distinctive precision instrument that runs 400 days without rewinding. It has been accurately timed and approved before leaving the home of highly skilled Schatz craftsmen.
When was the standard 400 day clock made?
Schatz Models with Model Name: Standard 400 Day Clock. There are 32 Models named Standard 400 Day Clock in the database. This 400 day clock with disc pendulum was made around 1900 to 1910. The brass base has a wooden insert. This 400 day clock with disc pendulum was made from mid-1923 to early 1927.
How does the suspension wire work on a 400 day clock?
The tube has two sections, the lower part (A) holds the suspension wire in position while the clock is in transit. 3) The lower section of the tube is held tight by a thumb screw (B). Loosen this screw and raise the lower part of the tube (A) upward as far as it will go, then tighten the thumb screw (B).
