How do I reset my Dometic refrigerator?

How do I reset my Dometic fridge?

Make sure all electrical power is disconnected from the RV.
Push and hold the ‘fridge reset’ button on the front of the control panel for 10 seconds.
Release the button, wait 10 seconds and then press and release it again.
Wait another 10 seconds and then press and release it once more.

Where is the reset button on a Dometic RV fridge?

Dometic RV Refrigerator Reset Button The most common location is inside the fridge section of the refrigerator. Some models have it in the freezer section and then the two or three-way models should be reset by flicking the circuit breaker off and then back on again.

Is there a reset button on an RV refrigerator?

Each model of camper fridges tends to have different placement of the reset button. However, the most common thing is that in most models the reset button is located inside the fridge. Once you open the door, you will immediately see the button. This will help you troubleshoot your fridge in case of any technicalities.

Why is my Dometic refrigerator too cold?

The most common reason your RV refrigerator might be over-cooling is because the thermistor/ thermostat inside the fridge is either turned up too high or isn’t working properly. Another common reason is warm, humid air from outside entering the refrigerator through and frosting over.

Why is my Dometic fridge not working on electric?

Check it if the Fridge is Plugged into a 13A socket If it is, you should check the fuse to make sure all is ok there. If the fuse has blown your fridge may start working again once it’s been replaced.

Why is the check light on on my Dometic refrigerator?

The check light on Dometic Refrigerator comes on and the unit isn’t cooling properly. It is set to Auto mode and the gas is turned off. When in auto the gas has to be turned on. When you loose power to it , it switches to gas automatically.

How do you adjust a Dometic thermistor?

To adjust the temperature in a Dometic RM2652, you are to move the plastic slide up to make the fridge colder. The plastic slide that holds the thermistor in mine was loose. Loose enough that when I slide it up the fin, the thermistor slide down the sleeve. Moving the slide did nothing to move the thermistor.

How do I know if my Dometic fridge is working?

The refrigerator is silent when running, either on gas or electric. If the panel indicated Gas and there was no check light, then it should be working. It may take up to 24 hours to fully cool down from ambient temperature.

Why isn’t my caravan fridge not working?

There are a few reasons behind this. First, it could be down to the thermocouple, which regulates how much gas is in the fridge’s burner at any time. If this component fails, it’s time to replace it. If replacing the thermocouple doesn’t fix the issue, perhaps your pilot light’s gas line has too much air in it.

How do I know if my Dometic Refrigerator is working?

How do I reset my Dometic 5 button thermostat?

To RESET the Dometic 5 Button Thermostat:
Press and Hold in the top and bottom buttons,
Turn ON the bottom On/Off switch.
FF will appear, release the buttons.
IF EE appears, there is a fault with the communication cable.

What is the coldest setting on a Dometic refrigerator?

The adjustable thermostat ranges from 1 – 5 (5 = coldest temperature setting). Refrigerator performance may be reduced in extremely cold (subzero) temperatures.

How do you test a Dometic thermistor?

Dometic Thermistor To test the Dometic thermistor, disconnect it from the main (lower) circuit board and place the other end (sensor end) into a glass of ice water. After a few minutes you should be able to get a resistance reading of 7,000 to 10,000 ohms between the two terminals of the connector.

What does the check light mean on a Dometic refrigerator?

How do I know if my Dometic fridge is working on gas?