How do I get my Kenmore dishwasher to unlock?
To release a stuck button, try turning off the breaker in the main panel and leaving it off for five minutes. That should allow the control panel to reset, and when you turn the power back on, the unit should be out of Lock mode. If not, press the “Heated Dry” button for four seconds.
How do you unlock a Kenmore Elite dishwasher model 665?
To unlock the dishwasher control panel, press and hold the NO HEAT DRY button for 4 deliberate seconds and the LOCK ON light should turn off. The control should then work normally.
How do I get the lock off my dishwasher?
To turn off Control Lock, press and hold the Options key that says “Control Lock Hold 3 Sec” under it for 3 seconds. If the dishwasher has a dedicated Control Lock button in the Options selections, press and hold CONTROL LOCK for 3 seconds.
How do I unlock my old Kenmore Elite dishwasher?
Why did my Kenmore dishwasher stop working?
The thermal fuse shuts off power to the dishwasher if it overheats. If the thermal fuse blows, it will prevent the dishwasher from starting. To determine if the thermal fuse is defective, use a multimeter to test the fuse for continuity. If the thermal fuse does not have continuity, replace it.
Why is my Kenmore dishwasher not filling with water?
Common solutions for: Kenmore Dishwasher won’t fill If the water valve is clogged or defective, water will not flow into the dishwasher. Water inlet valves are not repairable—if the valve is defective, you must replace it. If the float switch is defective or stuck, it might not stop the dishwasher from overflowing.
Why does my dishwasher Says control lock?
The control lock on a dishwasher is intended to “lock” the control from unintended use. It can be used while the dishwasher is operating or not. This is perfect for the household with children who like to touch buttons so the dishwasher cannot be turned on accidently or turned off when running.
How do I reset my Kenmore Elite ultraclean dishwasher?
A generic way to reset at Kenmore dishwasher is pressing the “heated dry” button then the “normal wash” button then again the “heated dry” then again the “normal wash”. After you press those four buttons in a row your dishwasher should begin a short 12 minutes test cycle during which the dishwasher will reset.
