How do I reset a Robertshaw thermostat?

How do I reset a Robertshaw thermostat?

To reset the thermostat, use a small object such as a tooth pick or paperclip and gently press the button located inside the small hole on the front of the thermostat housing labeled “reset”.

What does it mean when thermostat is blinking heat on?

Check the thermostat is set to heat, and see if the “Heat On” button is blinking. This indicates a safety timer has been tripped to protect your thermostat’s compressor. Once this stops blinking, your thermostat should be able to maintain its heat setting again.

Why is my Bryant thermostat blinking?

Our Bryant Heat Pump/AC Thermostat is flashing “heat on” but the unit will not turn on. That is normal for the thermostat to flash heat on for a short time then to remain on constant. Remove the thermostat cover and you should see a R G Y W O/B terminals.

What could cause a 3 Flash error code?

What it means: Have you ever looked at your furnace and thought what do 3 flashes on American Standard furnace mean? This error occurs when the combustion air pressure switch that monitors the flow of air through the vent system fails to close while the induced draft motor is operating.

How do I Reset a thermostat?

Here are the step-by-step reset instructions:

1. Turn your thermostat off by switching it to the off position.
2. Find the breaker that powers your HVAC system and turn it off.
3. Wait 30 seconds and turn the breaker back on.
4. Turn your thermostat back on.

When should I Reset my thermostat?

Anytime you suspect an issue with your HVAC system, resetting the thermostat should be your first course of action. Like personal electronics such as tablets and phones, sometimes these devices need a reset.

What does 3 flashing lights mean on my furnace?

Three LED flashes. This means your furnace has an open pressure switch circuit or the induced draft blower is operating when it shouldn’t be. Your heater might have a wiring problem that requires specialized help from Scott Temperature.