What plumbing is needed for a shower?

The water supply for a shower arrives via two pipes: hot and cold. In construction that is less than 30 years old, these pipes are usually copper. The pipes connect to a shower valve that controls the temperature and flow of water to the shower head.

How much does it cost to have a shower plumbed?

To install the plumbing for a standard shower, a you’ll likely pay $50 to $200 for a plumber. This price increases if the plumber will need to install any additional features.

What is the shower pipe called?

Shower Arm — Pipe that comes out of the wall and the showerhead threads onto. Shower Trim Plate — A trim plate is a decorative piece of brass that covers the rough in valve in tub/shower installations. Showerhead — An output devise that delivers water to the shower.

Can I use PEX for shower plumbing?

When doing a shower/tub valve — you can use PEX for the hot and cold supply and for the leg that goes from the shower head but NOT to the tub spout.

How do you test rough in shower plumbing?

Testing the Valve After the shower head is installed (and the tub spout, if using a combination shower and tub valve), turn on the cold water and let it run for 10 to 15 seconds. Then do the same for the hot side. If testing is being done with air, the procedure is the same.

What is the side of a bath called?

Rim: The upper edge of the tub. Cold and hot water supply: There’s a dedicated pipe for both cold and hot water. Drain: The part in the tub where water drains and enters the drain pipe that removes water.

What is the thing that water comes out of called?

Faucet: The faucet is the part of a sink where the water pours out. Parts of a sink faucet include a water spout, controls, gaskets, flanges, aerators, washers and an assortment of screws, depending on the kitchen or bathroom sink faucet you have in your home.